Software updates add to oscilloscope capabilities

Posted By : Barney Scott
Software updates add to oscilloscope capabilities

Two software updates for its real-time oscilloscope products have been announced by Keysight Technologies. The software updates are currently available in the Infiniium oscilloscope firmware version 5.60. The N8827A PAM-4 analysis software update adds bit error ratio (BER) capabilities for 4-level pulse amplitude modulation (PAM-4) based signals.

The N8834A MultiScope software update adds support for Keysight’s InfiniiVision oscilloscopes.

The N8827A PAM-4 analysis software update adds a BER and symbol error ratio (SER) measurement tool designed to help engineers perform BER and SER measurements on PAM-4 signals.

Measuring the BER or SER of a PAM-4 signal allows designers to fine tune the transmitter or receiver equalisation parameters of their PAM-4 devices by highlighting where burst error failures can impact a receiver’s forward error correction (FEC) protocol.

The N8827A software is supported on Keysight’s Infiniium S-Series, 90000A, V-Series and Z-Series oscilloscopes and; as well as the discontinued 90000X- and 90000 Q-Series oscilloscopes.

Historically, since many PAM-4 implementations take advantage of forward error correction, it is possible to operate a communication link that uses PAM-4 operating at a BER of 10e-6 or 10e-5 or even greater.

By comparison, traditional non-return-to-zero (NRZ) or PAM-2 based signaling technologies operate at a BER level of 10e-12 or lower.

At 10e-6 or greater, such BER calculations for PAM-4 signals are now well within the reasonable measuring capacity of the Infiniium Z-Series and V-Series real-time oscilloscopes.

In addition to BER measurement, this new feature allows engineers to also identify and locate burst errors on a continuous repeating patterns.

The N8834A MultiScope software enables engineers to connect multiple Infiniium and InfiniiVision oscilloscopes, allowing them to have up to 40 time-correlated analog channels available for signal acquisition.

Designers working on high-speed, multilane applications, such as optical networking, MIMO (multiple input multiple output) antennas, power rail analysis, DDR memory and high-speed serial standards, can gain insight faster, save money and improve their productivity using the N8834A MultiScope application to make simultaneous measurements across multiple lanes.

The 5.60 software release allows engineers to use MultiScope on InfiniiVision oscilloscopes while running the software on their PC. Previously, MultiScope only worked on Infiniium oscilloscopes.

Downloads


You must be logged in to comment

Write a comment

No comments




More from Keysight Technologies (formerly Agilent)

View & download Keysight product literature, application notes, specifications & brochures.

Literature

View & download Keysight technical support documentation, demos, manuals & selection/configuration guides.

Support

SPS IPC Drives 2017
28th November 2017
Germany Nuremberg
Cyber Security - Oil, Gas, Power 2017
29th November 2017
United Kingdom London
AI Tech World
29th November 2017
United Kingdom Olymipa, London
Maker Faire 2017
1st December 2017
Italy Rome
Virtual & Augmented Reality Creative Summit 2017
5th December 2017
United Kingdom Picturehouse Central, London